This product is a kit of 4 clips (2 upper and 2 lower) printed with ASA and is designed to be epoxied in place of the broken clips on the hatch wire boots. Design originally from user Gc9n on Thingiverse: https://www.thingiverse.com/thing:3246429
Products are direct shipped from Supplier.
Broke one of my rear hatch grommet clips when removing and used this piece to fix it. Glued it with some super glue. It was a little annoying to line up since it was pretty tight fit with the cables in the way and the repair clip needed to "float" a little since you needed it to line up at the top. You could push it down a little too much at the back and it wouldn't be level. I was impatient and only waited 15min before clipping it back in, but it's holding even after a couple of days. Hopefully the temperature changes where I live don't mess with the super glue enough to weaken it.
