Universal 2.5" Aluminum Intercooler Piping Kit 8PC 90 Degree Black
Universal 2.5" Aluminum Intercooler Piping Kit 8PC 90 Degree Black
Universal 2.5" Aluminum Intercooler Piping Kit 8PC 90 Degree Black
Universal 2.5" Aluminum Intercooler Piping Kit 8PC 90 Degree Black
Universal 2.5" Aluminum Intercooler Piping Kit 8PC 90 Degree Black
Universal 2.5" Aluminum Intercooler Piping Kit 8PC 90 Degree Black

Universal 2.5" Aluminum Intercooler Piping Kit 8PC 90 Degree Black

Regular price $200.00 Sale price$159.99 Save $40.01
/

  • Direct Shipped
Universal 2.5" Aluminum Intercooler Piping Kit 8PC 90 Degree Black

Eight-piece aluminum piping set with 90-degree fittings designed for custom intercooler tubing runs. Constructed from lightweight aluminum with black anodized finish to resist corrosion. Fits 2.5" diameter hose and tubing systems across turbocharged and supercharged builds.

✓ Ships from FL Warehouse ✓ Aluminum Construction ✓ 8-Piece Kit
Key Features
  • 90-Degree Elbows - Tight bends reduce packaging space and hose routing complexity on tight engine bays
  • Black Anodized Finish - Corrosion-resistant coating holds up to boost pressure cycles and thermal cycling
  • Universal Sizing - Works with any 2.5" hose and clamp system, no vehicle-specific fitment required
Specs
  • Material: Aluminum
  • Diameter: 2.5"
  • Finish: Black Anodized
  • Configuration: 8-Piece Kit with 90-Degree Fittings
  • Condition: New
Whats Included
  • 8 Aluminum Piping Pieces with 90-Degree Elbows
Frequently Asked Questions

Do I need hose clamps to connect these pieces?

Yes. These are bare aluminum fittings designed to work with standard worm-gear or band-style clamps. You'll need to source appropriately-sized clamps for your 2.5" hose diameter.

Will these pieces need any prep before installation?

The black anodized finish is ready to install as-is. If you're painting them to match your engine bay, degrease with soap and water first, then sand lightly with 220-grit before primer and paint.

Can I test-fit these before permanently sealing everything?

Absolutely. Test the layout with clamps hand-tightened first. Once you've confirmed the run, tighten clamps fully and torque according to your clamp manufacturer's spec—typically 4–8 ft-lbs for worm-gear clamps.

Products are direct shipped from Supplier.

This site is protected by hCaptcha and the hCaptcha Privacy Policy and Terms of Service apply.


Recently viewed