Intake Manifold for 2007-2012 Chevrolet Cobalt HHR Malibu 2.2L 2.4L
Intake Manifold for 2007-2012 Chevrolet Cobalt HHR Malibu 2.2L 2.4L
Intake Manifold for 2007-2012 Chevrolet Cobalt HHR Malibu 2.2L 2.4L
Intake Manifold for 2007-2012 Chevrolet Cobalt HHR Malibu 2.2L 2.4L
Intake Manifold for 2007-2012 Chevrolet Cobalt HHR Malibu 2.2L 2.4L
Intake Manifold for 2007-2012 Chevrolet Cobalt HHR Malibu 2.2L 2.4L
Intake Manifold for 2007-2012 Chevrolet Cobalt HHR Malibu 2.2L 2.4L

Intake Manifold for 2007-2012 Chevrolet Cobalt HHR Malibu 2.2L 2.4L

Regular price $210.00 Sale price$169.99 Save $40.01
/

  • Direct Shipped
Intake Manifold — 2.2L / 2.4L Gasket Set

Direct replacement intake manifold assembly engineered for reliable bolt-on installation. OEM-style design maintains factory air and fuel delivery geometry. Hard panel construction built to handle daily driving and consistent engine temperatures.

✓ Ships from FL Warehouse ✓ Factory Mounting Points ✓ Direct-from-Warehouse
Key Features
  • Factory mounting configuration - Bolt pattern matches OEM locations, no drilling or modification required
  • Stock air passage design - Maintains original intake velocity and fuel atomization for consistent performance
  • Thermal management - Hard panel construction dissipates heat without warping under normal engine load
Specs
  • Hard panel construction
  • OEM-style gasket surfaces
  • Single unit assembly
Whats Included
  • Intake manifold assembly only
Frequently Asked Questions

Do I need to replace the gaskets when installing this manifold?

Yes. Old gaskets compress and won't seal properly against the new manifold. Use fresh gaskets and torque fasteners to your vehicle's service manual spec for a reliable seal.

Can I reuse my original fuel injectors and sensors with this manifold?

Most factory injectors and temperature sensors are compatible, but verify your specific configuration before removal. Some sensor ports may vary — test-fit and confirm mounting before finalizing installation.

What surface prep is needed before bolting this on?

Clean the mounting surfaces on the cylinder head and block with a gasket scraper to remove old gasket material and debris. Wipe with a clean cloth before assembly. Primer or paint is not required for internal engine components.

Products are direct shipped from Supplier.

This site is protected by hCaptcha and the hCaptcha Privacy Policy and Terms of Service apply.


Recently viewed