2007-2009 Nissan Altima Fog Lights w/ Switch & H11 Bulb
2007-2009 Nissan Altima Fog Lights w/ Switch & H11 Bulb
2007-2009 Nissan Altima Fog Lights w/ Switch & H11 Bulb
2007-2009 Nissan Altima Fog Lights w/ Switch & H11 Bulb
2007-2009 Nissan Altima Fog Lights w/ Switch & H11 Bulb
2007-2009 Nissan Altima Fog Lights w/ Switch & H11 Bulb

2007-2009 Nissan Altima Fog Lights w/ Switch & H11 Bulb

Regular price $100.00 Sale price$79.99 Save $20.01
/

  • Direct Shipped
2007–2009 Nissan Altima Fog Lights with Switch & H11 Bulb

Factory-style fog light kit built to bolt straight into your Altima's bumper opening. Includes both lights, integrated switch, and H11 bulbs ready to wire in. Hard panel construction matches OEM appearance and fitment.

✓ Ships from FL Warehouse ✓ Bulb Included ✓ In-House Quality Check
Key Features
  • Integrated dash switch – Wired control without aftermarket relay headaches
  • H11 bulbs pre-installed – Ready to connect, no separate bulb purchase needed
  • OEM-style housing – Sits flush in factory openings, zero modification required
Specs
  • Material: Hard panel construction
  • Bulb type: H11
  • Includes: Left and right fog lights, integrated switch, H11 bulbs
What's Included
  • Left fog light assembly
  • Right fog light assembly
  • Integrated dashboard switch
  • H11 bulbs (pre-installed)
Frequently Asked Questions

Do I need to splice into existing wiring or can I tap into the factory harness?

The switch connects to your vehicle's harness—exact routing depends on your electrical setup. Run the harness along the driver's side inner fender and route through the firewall. No factory splice points are confirmed, so plan on manual routing and securing with clips.

What if one of the H11 bulbs burns out after I install them?

H11 bulbs are a standard size and widely available at any auto parts store. They're inexpensive and swap in seconds, so keep a spare on hand.

Do these lights require any sealant or adhesive where they meet the bumper?

The housings are designed for factory-style bolt mounting. Seal around the perimeter with weatherstrip adhesive or silicone sealant to keep moisture out of the engine bay.

Products are direct shipped from Supplier.

This site is protected by hCaptcha and the hCaptcha Privacy Policy and Terms of Service apply.


Recently viewed