2.75" V-Band Exhaust Clamp
- Direct Shipped
2.75" V-Band Exhaust Clamp
Quick-release V-band clamp sized for 2.75-inch diameter exhaust tubing. Designed for bolt-together exhaust systems where you need repeatable clamping without welding. Works with turbo downpipes, intercooler piping, and custom exhaust builds where modular connections matter.
Key Features
- V-Band coupling - Creates a sealed joint without permanent attachment; pull the clamp band to break the connection and swap components in minutes.
- 2.75-inch bore - Matches common turbo and intercooler piping diameters; test your tubing OD before ordering to confirm fit.
- Bolt-together assembly - No welding required; tighten bolts evenly to seat the seal properly.
Specs
- Bore diameter: 2.75"
- Type: V-Band clamp with bolt fasteners
What's Included
- V-Band clamp assembly
- Fastening hardware
Frequently Asked Questions
Will this clamp work on both sides of my intercooler or piping?
V-bands are designed as male-to-male connectors, so you'll need matching V-band flanges welded or attached to both ends of your tubing. The clamp itself doesn't seal against bare pipe.
How tight should I tighten the bolts?
Tighten bolts evenly in a cross pattern until the band is snug and the mating surfaces are fully seated. Over-torquing can warp the band; hand-tight-plus-a-half-turn is a solid starting point, then check for leaks under boost.
Can I reuse this clamp multiple times if I'm building a modular system?
Yes—that's the whole point of V-band. Unbolt the clamp, separate your piping, swap components, and re-clamp. Make sure the V-band flanges stay clean and undamaged for a good seal each time.
Products are direct shipped from Supplier.