1.75" to 2.00" Silicone Reducer Hose with 90 Degree Bend - Black
- Direct Shipped
1.75" to 2.00" Silicone Reducer Hose with 90 Degree Bend — Black
Silicone hose that steps down from 1.75" to 2.00" with a sharp 90-degree bend. Built from silicone construction for durability in high-temperature applications. The angled configuration handles tight engine bay routing and radiator hose transitions without kinking.
Key Features
- 90-degree elbow design - Eliminates the need for multiple hose pieces and adapter fittings in tight spaces.
- Silicone material - Resists heat and coolant degradation better than standard rubber hose.
- Stepped diameter - Reducer fitting built in; no separate coupling required.
Specs
- Material: Silicone
- Configuration: 1.75" inlet to 2.00" outlet with 90-degree elbow bend
- Condition: New
Whats Included
- 1x Silicone Reducer Hose
Frequently Asked Questions
Do I need clamps or hose barbs to install this?
This hose is designed to fit over barbed fittings or hard pipe connections. You'll need spring clamps or worm-gear clamps (sized for 1.75" and 2.00" diameters) to secure both ends. These are not included.
Can I use this for both coolant and boost lines?
Silicone hose handles both applications. For coolant, you're solid. For boost, confirm your turbo or supercharger specs match the pressure rating of this hose — most silicone reducers work fine up to moderate boost levels, but always verify before plumbing.
Will this hose require any prep before installation?
Wipe the barbed fittings clean before sliding the hose on. Some builders dip the barbs in soapy water to ease insertion. No sanding, priming, or painting needed — it ships ready to install.
Products are direct shipped from Supplier.