1/4 Inch NBR Fuel Line Hose - 10 Foot Length
1/4 Inch NBR Fuel Line Hose - 10 Foot Length
1/4 Inch NBR Fuel Line Hose - 10 Foot Length
1/4 Inch NBR Fuel Line Hose - 10 Foot Length

1/4 Inch NBR Fuel Line Hose - 10 Foot Length

Regular price $80.00 Sale price$59.99 Save $20.01
/

  • Direct Shipped
1/4 Inch NBR Fuel Line Hose — 10 Foot Length

NBR rubber fuel line rated for carburetor and fuel injection systems. Ten feet of 1/4-inch hose gives you room to route cleanly from tank to engine bay without patching multiple sections together. Built tough for street and strip use.

✓ Ships from FL Warehouse ✓ NBR Construction ✓ 10 Foot Length
Key Features
  • NBR Rubber Compound - Resists fuel degradation and temperature swings without cracking or leaking.
  • Universal 1/4-Inch Diameter - Fits standard carb and EFI fuel line connections across most fuel systems.
  • Single 10-Foot Section - One continuous run eliminates mid-line splices and reduces potential failure points.
Specs
  • Material: NBR Rubber
  • Diameter: 1/4 Inch
  • Length: 10 Feet
  • Condition: New
Whats Included
  • 1x 1/4 Inch NBR Fuel Line Hose (10 Feet)
Frequently Asked Questions

Do I need hose clamps to connect this?

Hose clamps are not included with this hose. You'll need to source worm-gear or spring clamps to secure each end to your fuel line fittings — standard sizes work fine with 1/4-inch hose.

Can I use this on a high-pressure fuel injection system?

NBR hose handles standard carb and EFI pressures without issue. If you're running forced induction or direct injection above typical pump pressure, check your system specs first — this is general-duty fuel line.

Will this hose need prep before I install it?

No prep required. Cut to length as needed, slide onto your barbed fittings, and clamp it down. Make sure both ends are fully seated before tightening clamps.

Products are direct shipped from Supplier.

This site is protected by hCaptcha and the hCaptcha Privacy Policy and Terms of Service apply.


Recently viewed