09-17 Chevrolet Traverse Mirror Glass Lens w/ Heated Defroster Left
09-17 Chevrolet Traverse Mirror Glass Lens w/ Heated Defroster Left
09-17 Chevrolet Traverse Mirror Glass Lens w/ Heated Defroster Left
09-17 Chevrolet Traverse Mirror Glass Lens w/ Heated Defroster Left
09-17 Chevrolet Traverse Mirror Glass Lens w/ Heated Defroster Left

09-17 Chevrolet Traverse Mirror Glass Lens w/ Heated Defroster Left

Regular price $140.00 Sale price$109.99 Save $30.01
/

  • Direct Shipped
09-17 Chevrolet Traverse Mirror Glass Lens w/ Heated Defroster — Left

Direct replacement mirror glass with integrated heating element for the driver's side. Hard panel construction with factory defroster grid designed to clear condensation and frost in cold weather. Pre-cut to fit your existing mirror housing without modification.

✓ Factory Mounting Points ✓ In-House Quality Check ✓ Ships from FL Warehouse
Key Features
  • Heated Defroster Grid - Warms up to melt ice and fog without waiting for cabin heat to cycle through
  • Drop-In Fit - Designed to seat into factory mirror housing — no cutting or drilling required
  • Left-Side Application - Driver's mirror only; order right-side lens separately if needed
Specs
  • Configuration: Heated mirror glass lens assembly
  • Application: Left side
  • Condition: New
What's Included
  • Mirror glass lens with heating element
Frequently Asked Questions

Do I need to remove the entire mirror assembly to install this?

No. This lens is designed to swap into your existing mirror housing from the front. Depending on your mirror's design, you may need to remove trim pieces or the mirror backing, but the mirror bracket stays mounted to the door.

Will the heater work right away or does it need any special wiring?

The heating element connects to the factory mirror heating circuit in your door harness. If your vehicle already has heated mirrors, it'll activate through the OEM switch. If not, you'll need to verify your door wiring supports the circuit before installation.

What if the lens doesn't sit flush after I install it?

Test-fit the lens before fully seating it. Check that no trim clips are bent or blocking the housing. If the glass wobbles after installation, remove it and verify the housing backing plate isn't damaged. Contact support with photos if the fit remains loose after checking hardware.

Products are direct shipped from Supplier.

This site is protected by hCaptcha and the hCaptcha Privacy Policy and Terms of Service apply.


Recently viewed