09-14 Ford F-150 Crew Cab 5.5" Straight Nerf Bars with Brackets
09-14 Ford F-150 Crew Cab 5.5" Straight Nerf Bars with Brackets
09-14 Ford F-150 Crew Cab 5.5" Straight Nerf Bars with Brackets
09-14 Ford F-150 Crew Cab 5.5" Straight Nerf Bars with Brackets
09-14 Ford F-150 Crew Cab 5.5" Straight Nerf Bars with Brackets
09-14 Ford F-150 Crew Cab 5.5" Straight Nerf Bars with Brackets

09-14 Ford F-150 Crew Cab 5.5" Straight Nerf Bars with Brackets

Regular price $520.00 Sale price$429.99 Save $90.01
/

  • Direct Shipped
09-14 Ford F-150 Crew Cab 5.5" Straight Nerf Bars with Brackets

Steel step bars built for crew cabs, bolted straight across the rocker panels. These mount flush with factory points and come with all brackets needed for installation. Hard-wearing steel construction handles daily use without flex or rattle.

✓ Factory Mounting Points ✓ Complete Bracket Kit Included ✓ Ships from FL Warehouse
Key Features
  • 5.5" tubular design - Wide foot platform for safe entry and exit without pinching your hands or pant legs.
  • Straight profile - Clean lines that sit tight to the body, no curves or swept geometry to snag accessories or brush curbs.
  • Crew cab specific - Cut and bracketed for rear door clearance, so steps sit where you actually need them.
Specs
  • Material: Steel
  • Configuration: Straight tube bars with factory-point brackets
  • Condition: New
  • Quantity: Pair (driver + passenger side)
Whats Included
  • Two nerf bars (left and right)
  • Mounting brackets
  • Hardware for installation
Frequently Asked Questions

Do these bolt to the factory rocker panel holes, or do I need to drill?

They bolt to existing factory mounting points — no drilling. Line up the brackets and you're ready to fasten down.

Will these fit under a tonneau cover or bed cover?

Check your cover's side profile first. These mount at the rocker, so most soft or hard tonneau covers clear them, but a low-profile bed cover may interfere. Measure the gap on your setup before committing.

What prep work do the bars need before I bolt them on?

They ship ready to install. If you want to paint them to match or protect the steel, degrease and sand lightly before priming — but bare steel is fine if you're going with that look and don't mind eventual patina.

Products are direct shipped from Supplier.

This site is protected by hCaptcha and the hCaptcha Privacy Policy and Terms of Service apply.


Recently viewed