05-15 Nissan Titan / 05-07 Armada Clear Fog Lights - No Switch
05-15 Nissan Titan / 05-07 Armada Clear Fog Lights - No Switch
05-15 Nissan Titan / 05-07 Armada Clear Fog Lights - No Switch
05-15 Nissan Titan / 05-07 Armada Clear Fog Lights - No Switch
05-15 Nissan Titan / 05-07 Armada Clear Fog Lights - No Switch
05-15 Nissan Titan / 05-07 Armada Clear Fog Lights - No Switch

05-15 Nissan Titan / 05-07 Armada Clear Fog Lights - No Switch

Regular price $100.00 Sale price$79.99 Save $20.01
/

  • Direct Shipped
Clear Fog Lights for Nissan Titan / Armada

Direct replacement fog lights with crystal-clear lens design for improved visibility and a cleaner front-end appearance. These units mount at factory locations and come without an integrated switch, allowing you to wire them to your existing controls or aftermarket harness. Built as a straightforward bolt-on for drivers who want better low-beam coverage without rewiring their entire lighting circuit.

✓ Factory Mounting Points ✓ Direct-from-Warehouse ✓ Ships from FL Warehouse
Key Features
  • Clear Lens Construction - Cuts through haze and road spray, keeps your sight lines sharp in low-light conditions.
  • Factory Mounting - Drops into existing fog light buckets with no modification needed.
  • No Integrated Switch - Gives you control: wire to OEM switches, relay harnesses, or custom setups without fighting factory circuits.
Specs
  • Hard panel construction with clear lens
  • Designed for factory mounting locations
  • No switch or control module included
Whats Included
  • Fog light units only
Frequently Asked Questions

Will I need to run new wiring or can I use the factory harness?

Factory harnesses work, but these lights don't come with a switch. If your truck has fog light wiring already, you can tap into it. If not, you'll need a relay harness—most guys grab a simple 40-amp relay kit and run power from the battery. Depends on what you've got under the hood.

Do these bolt straight into the existing fog light buckets?

Yes. They mount at factory points with no drilling or bracket fabrication required. Test-fit before you tighten everything down to make sure the lens sits flush.

What if I need to brighten or refocus the beam after install?

Most fog lights have internal aiming adjusters. Once they're bolted in place, you can fine-tune the beam direction slightly. If the output feels weak, check that your power supply is solid—low voltage kills brightness faster than anything else.

Products are direct shipped from Supplier.

This site is protected by hCaptcha and the hCaptcha Privacy Policy and Terms of Service apply.


Recently viewed