04-08 Ford F-150 / 06-08 Lincoln Mark LT 5" Oval Nerf Step Bars Black
04-08 Ford F-150 / 06-08 Lincoln Mark LT 5" Oval Nerf Step Bars Black
04-08 Ford F-150 / 06-08 Lincoln Mark LT 5" Oval Nerf Step Bars Black
04-08 Ford F-150 / 06-08 Lincoln Mark LT 5" Oval Nerf Step Bars Black
04-08 Ford F-150 / 06-08 Lincoln Mark LT 5" Oval Nerf Step Bars Black
04-08 Ford F-150 / 06-08 Lincoln Mark LT 5" Oval Nerf Step Bars Black

04-08 Ford F-150 / 06-08 Lincoln Mark LT 5" Oval Nerf Step Bars Black

Regular price $410.00 Sale price$339.99 Save $70.01
/

  • Direct Shipped
04-08 Ford F-150 / 06-08 Lincoln Mark LT 5" Oval Nerf Step Bars Black

Black oval tube step bars bolt to the rocker panel for easier entry and a protective side guard. Hard panel construction with a powder-coated finish resists rust and weathering. Pre-drilled for factory mounting points—no custom fabrication required.

✓ Factory Mounting Points ✓ Powder-Coated Black Finish ✓ Ships from FL Warehouse
Key Features
  • 5" oval tube diameter - Provides a solid step platform and added side protection without excessive bulk.
  • Rocker panel mounting - Attaches at factory points; no drilling or welding needed.
  • Black powder coat - Factory-applied finish resists chips, fading, and corrosion in all weather.
Specs
  • Material: Steel tube with powder-coated finish
  • Configuration: Dual side bars (left and right)
  • Condition: New
Whats Included
  • Left and right nerf step bars
Frequently Asked Questions

Do these mount at the factory rocker points?

Yes. These bolt directly to the factory attachment points on the rocker panel—no drilling, cutting, or welding. You'll need basic hand tools and fasteners rated for your truck's spec.

What bolts and hardware do I need to install these?

The bars come ready to mount, but fasteners are not included. Use stainless steel or Grade 8 bolts matched to your factory rocker attachment holes. Refer to your truck's service manual for correct bolt size and torque specs.

Can I paint or refinish the black bars later if they get damaged?

The bars ship with a factory powder coat. If they scuff or chip, you can sand the damaged area and use high-heat engine enamel or automotive touch-up paint to patch them. For a full refinish, light sanding and a rattle can or spray system works fine on steel tube.

Products are direct shipped from Supplier.

This site is protected by hCaptcha and the hCaptcha Privacy Policy and Terms of Service apply.


Recently viewed