Splitter Endplate Wear Pads / Scuff Plates - Vertical mounting (Titanium pucks)

Protect your endplates with these vertical titanium pucks. Made of .187" thick titanium plate. Each plate comes with two 5mm holes and hardware to be mounted to your endplates. These are compatible with our V3 Track Splitter Endplates, or diy for your own endplate. Designed to be mounted vertically on the edge of a blade, or at the bottom of a foot plate / endplate / end fence. 

NOTE! They should not be used flat on a blade - the bolt will grind off before the puck. 

Pucks Sold Individually. 

Single includes:

- qty 1 - Titanium puck & hardware

2 Pack includes:

- qty 2 - Titanium pucks & hardware

4 Pack includes:

- qty 4 - Titanium pucks & hardware

Looking for other splitter parts?

• Other Splitter DIY / Replacement Parts

Disclaimer - 

Off road use only, not intended to be used on public roads. This product is not DOT approved. This product may alter the handling of the vehicle. The buyer is responsible for all modifications made to your car. CJM Industries llc assumes no responsibility or liability as a result from altering your car with our products. This product may not comply with Federal, State, Province, and/or Local laws, ordinances, and regulations. Buyer takes all responsibility to conform to all applicable laws and regulations for road use, especially pertaining to safety.